SOLZAIMA Hidro 12, Инструкция по эксплуатации

Страница: 24 / 147

18
8. Using the Free-Standing Pellet Fire
The pellet stoves must be serviced as described in point 3.6, page 110
(Warranty). In order to adjust the operating parameters of the stove (pellet stove),
the dosing must be adjusted as described in section 7 of this manual. The pellet dose
must be adjusted according to the gas temperature and pellet consumption of the
appliance at the rated power described in Table 1, page 5, in order to ensure that the
appliance delivers the correct power.
Recommendations
Before starting up the unit, please check the following:
• Ensure the unit is properly connected to the power mains using the 230V AC power
cable.
Figure 13 - Electric power plug
Check if the pellet reservoir is supplied with pellets. Inside the pellet reservoir is a
safety grid to prevent users from reaching the worm screw.
• Ensure that before each ignition the burner is clear.
The unit’s combustion chamber and panel door are made of iron plate
painted with high temperature resistant paint which releases fumes during
the initial burn due to the paint’s curing process. Avoid touching the unit
during its first burn to prevent leaving permanent marks on the paint. The
paint goes through a more plastic phase during the curing process. The curing
of the paint occurs at approximately 300ºC for 30 minutes.