SMC Networks AMS20, Руководство по эксплуатации

Страница: 69 / 137

-68-
No.PF
※※
-OMA1007
■ Default setting
Function
Default Settings
Sub display
(Right)
Applicable
Page
Main display
(Right)
Main display
(Left)
Sub display
(Left)
[F 0]
FLoW [rEF ] Select display units [ Std] Standard condition
Page 69
FLoW
[Unit] Units selection function
∗
1
[ L] L/min
tEMP [ C] o C
PrES [ MPA] MPa
[F 1] [SW1 ] Not Applicable on this product.
[F 2] [SW2 ] Not Applicable on this product.
[F 3]
FLoW
[FiL ] Select digital filter
[ 1.0] 1 second
Page 71
PrES [0.10] 0.1 second
[F 6] PrES
[FSC ] Display value fine
adjustment
[ 0.0] 0
％
Page 72
[F13] - [rEv ] Select reverse display [ oFF] Reverse display OFF Page 73
[F14]
FLoW
[CUt ] Select Zero cut-off setting
[ 1.0] 1
％
F.S. cut
Page 74
PrES
[ 0.0] 0
％
[F16]
PrES
[MES ] Measurement display
setting
[diSP] Display
Page 77 tEMP [diSP] Display
AC [diSP] Display
[F30] AC [SAvE] Accumulated value hold [ oFF] Not stored Page 78
[F33] [Po_E] Not Applicable on this product.
[F40]
-
[FrtE] Standby flow rate
(Threshold)
[25] AMS series
[50] AMS30 series
[100] AMS40 series
[200] AMS60 series
Page 79
-
[FHyS] Standby flow rate
(Hysteresis)
[100] AMS20 series
[200] AMS30 series
[300] AMS40 series
[400] AMS60 series
- [t_on] Standby ON delay [600] 600 seconds
- [t_oFF] Standby OFF delay [0] 0 second
- [iSoL] Auto isolation [OFF] Auto isolation OFF
- [t_iSo] Isolation delay [3600] 3600 seconds
[F41] - [SEt] Force AMS mode
[AMS] No Forced
[oP] Forced Operation mode
[Sb] Forced Standby mode
[iSoL] Forced Isolation mode
Page 82
[F80]
-
[diSP] Display OFF mode [ on] Display ON Page 83
[F81] [Pin ] Security code [ oFF] Not used Page 84
[F90] [ALL ] Setting of all functions [ oFF] Not used Page 86
[F96] [CYCL] Check of cycle time [- - -. -] No input signal Page 87
[F98] [tESt] Setting of output check [ n] Normal output Page 88
[F99] [ini ] Reset to the default settings [ oFF] Not used Page 92
∗
1
：
Setting is only possible for models with the units selection function.