Siemens SITRANS F M Intermag 2, Руководство по эксплуатации

Страница: 46 / 130

Commissioning
4-2
SITRANS FM Intermag 2 Flow Transmitter
Operating Manual - A5E00102775-03
4.1 Safety Instructions
!
Warning
Certain parts inside the device carry dangerous high voltage. The
housing must be closed and grounded before switching the device on.
!
Warning
The sensor connected to this device can be operated with high
pressure and corrosive media. Therefore serious injuries and/or
considerable material damage cannot be ruled out in the event of
improper handling of the device.
4.2 Preparations for Commissioning
After switching on the power supply, the device runs a self-test which
last about 30 seconds.
If the sensor has a SmartPLUG, the factory data of the sensor as well
as essential customer-specific tag data (range, units for flow and
totalizers, flow limit values, medium density, operating language) are
transferred to the transmitter the first time you switch on. The tag data
can then be changed permanently in the transmitter. These data are
not read in again until a new sensor is connected.
Note !
When replacing with the Intermag 1 transmitter you only have the flow
units of the SITRANS FM Intermag 2 transmitter according to the
3.1.1 menu item at your disposal.
Other units are automatically converted into similar units of the
SITRANS FM Intermag 2.
All data for configuring the signal outputs are not taken from the sensor
in the SITRANS FM Intermag 2 and must always be set on the
transmitter.
The measuring system is then immediately ready for operating and
starts measuring automatically.
Other application-related settings can be found in table 5-1 in section
3.2.1 ) .