Siemens Simatic RTU3030C, Руководство по эксплуатации

Страница: 110 / 392

Configuration (WBM)
4.9 Start page
RTU303xC
110
Operating Instructions, 06/2019, C79000-G8976-C382-06
Navigation in the WBM
By clicking on an entry in the navigation area on the left open the WBM page you want for
further information or on which you want to configure or program.
The WBM opens the first tab of the entry.
4.9.2 Status
The tab provides an overview of important status data of the RTU. Some of the display
parameters are commented on below.
Note on navigation:
By clicking on the titles (bold and underlined) of the parameter groups you jump directly to
the relevant WBM page.
General
Information on the device and the configuration data of the station
● Program execution
Runtime status of the program (controller)
● Station name
The station name configured in "System" > "General".
● System runtime (dd:hh:mm:ss)
Runtime of the RTU since commissioning or since the last restart
Power supply
Information about the battery module being used or about the external power supply
● Day of the last battery change
Time of the last changeover of the battery currently being used (when one battery module
is empty and there was a changeover to the other one).
● Remaining capacity (HW2)
Remaining capacity of all available batteries in mAh.
Ethernet interface
Information on the LAN interface
Logging
Information on logging and the SD card
Extension board
Information on the status of the extension board