Siemens RUGGEDCOM ROX II, Руководство пользователя

Страница: 726 / 798

Chapter 15
Network Discovery and Management
RUGGEDCOM ROX II
CLI User Guide
680 Managing SNMP Security Model Mapping
no admin snmp snmp-user id name
Where:
•
id
is the ID for the user
• name is the name of the user
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 15.2.8
Managing SNMP Security Model Mapping
This section describes how to manage the mapping of SNMP security models.
CONTENTS
• Section 15.2.8.1, “Viewing a List of SNMP Security Models”
• Section 15.2.8.2, “Adding an SNMP Security Model”
• Section 15.2.8.3, “Deleting an SNMP Security Model”
Section 15.2.8.1
Viewing a List of SNMP Security Models
To view a list of SNMP security models configured on the device, type:
show
running-config admin snmp snmp-security-to-group
If target addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-security-to-group | tab
SECURITY USER
MODEL NAME GROUP
-----------------------------
v1 oper all-rights
v1 guest all-rights
v2c oper all-rights
v2c admin testgroup
v2c guest all-rights
v3 admin initial
!
!
If no SNMP security models have been configured, add security models as needed. For more information, refer to
Section 15.2.8.2, “Adding an SNMP Security Model” .
Section 15.2.8.2
Adding an SNMP Security Model
To add an SNMP security model, do the following:
1. Make sure the CLI is in Configuration mode.