Siemens RUGGEDCOM ROX II, Руководство пользователя

Страница: 735 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 16
Traffic Control and Classification
Adding an Egress Source Port 689
!
If no egress source ports have been configured, add egress source ports as needed. For more information, refer to
Section 16.1.2.2, “Adding an Egress Source Port” .
Section 16.1.2.2
Adding an Egress Source Port
To add an egress source port for port mirroring, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the egress source port by typing:
switch
port-mirroring egress-src slot port
Where:
•
slot
is the name of the module location
•
port
is the port number (or a list of ports, if aggregated in a port trunk) for the module
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 16.1.2.3
Deleting an Egress Source Port
To delete an egress source port for port mirroring, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address by typing:
no switch port-mirroring egress-src
slot port
Where:
•
slot
is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 16.1.3
Managing Ingress Source Ports
This section describes how to configure and manage egress source ports for port mirroring.
CONTENTS
• Section 16.1.3.1, “Viewing a List of Ingress Source Ports”
• Section 16.1.3.2, “Adding an Ingress Source Port”
• Section 16.1.3.3, “Deleting an Ingress Source Port”