Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
498
Adding a Network
Section 13.8.7.2
Adding a Network
To add a network for the BGP protocol, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the network by typing:
routing
bgp network
address
Where:
•
address
is the IP subnet address and prefix for the network
3. If necessary, configure an event tracker to track network commands. For more information, refer to
Section 13.8.7.3, “Tracking Commands for a BGP Network”
4. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 13.8.7.3
Tracking Commands for a BGP Network
Network commands can be tracked using event trackers configured under
global » tracking
. For more
information about event trackers, refer to
Section 13.5, “Managing Event Trackers”
.
The network command is activated based on the event tracker's state. The
apply-when
parameter determines
when the command is activated. For example, if the
apply-when
parameter is set to
down
, the network
command becomes active (thereby advertising the network to a router's BGP peers) when the tracked target is
unavailable.
To track a command for a BGP network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to
routing » bgp » network » {address} » track
, where
{address}
is the IP subnet address and prefix
for the network.
3. Configure the following parameter(s) as required:
Parameter
Description
event { event }
Synopsis:
A string
Select an event.
This parameter is mandatory.
apply-when { apply-when }
Synopsis:
{ up, down }
Default:
up
Advertises the network when the tracked event state goes UP or stops advertising the
network when the tracked event goes DOWN.
4. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 13.8.7.4
Deleting a Network
To delete a network configured for the BGP protocol, do the following:
1. Make sure the CLI is in Configuration mode.
Содержание RUGGEDCOM ROX II
