Siemens RUGGEDCOM ROX II, Руководство пользователя

Страница: 243 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 6
Security
Adding a Host 197
!
If no hosts have been configured, add hosts as needed. For more information, refer to Section 6.9.11.2, “Adding a
Host” .
Section 6.9.11.2
Adding a Host
To add a new host for a firewall, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the host by typing:
security
firewall fwconfig firewall fwhost name
Where:
•
firewall
is the name of the firewall
•
name
is the name of the host
3. Configure the host by typing the following commands:
Parameter Description
ipsec Synopsis: { true, false }
Default: false
Parameter Description
iptype { iptype } Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used, otherwise define IPv4 and
IPv6 rules for each type of addresses used.
zone { zone } Synopsis: A string
A pre-defined zone
This parameter is mandatory.
interface { interface } Synopsis: A string
A pre-defined interface to which optional IPs and/or networks can be added.
This parameter is mandatory.
ipaddress { ipaddress } Synopsis: A string
Additional IP addresses or networks - comma separated, or a range in the form of
low.address-high.address
description { description } Synopsis: A string
(Optional) The description string for this host.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 6.9.11.3
Deleting a Host
To delete a host, do the following: