Siemens RUGGEDCOM ROX II, Руководство пользователя

Страница: 382 / 798

Chapter 10
Serial Server
RUGGEDCOM ROX II
CLI User Guide
336 Deleting a Serial Port Protocol
Parameter Description
local-port { local-port } Synopsis: A 32-bit signed integer between 1024 and 65535
The local TCP/UDP port to use to accept incoming connections.
transport { transport } Synopsis: { tcp, udp }
Default: tcp
The transport connection protocol (UDP or TCP).
4. If the transport connection protocol is set to UDP, configure one or more remote hosts for the port. For more
information about adding a remote host, refer to Section 10.5.2, “Adding a Remote Host” .
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 10.2.7
Deleting a Serial Port Protocol
To delete a serial port protocol, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the serial port protocol by typing:
no interface serial slot port protocols protocol
Where:
•
slot
is the name of the module location
•
port
is the port number (or a list of ports, if aggregated in a port trunk) for the module
•
protocol
is the protocol type
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 10.3
Managing Device Address Tables
This section describes how to manage DNP addresses in the local Device Address Table.
CONTENTS
• Section 10.3.1, “Viewing a List of Device Address Tables”
• Section 10.3.2, “Adding a Device Address Table”
• Section 10.3.3, “Deleting a Device Address Table”
Section 10.3.1
Viewing a List of Device Address Tables
To view a list of Device Address tables configured for a serial port using the DNP protocol, type:
show running-config interface serial
slot/port
protocols dnp setdnp device-table