3.8.4 RF repeater AVS14.390
•
To establish the radio connection, the device must be provisionally connected to
power prior to mounting, enabling the radio connection to be opened and tested.
•
The RF repeater must be fitted inside the building
Mounting method
1
2359Z30
2
2359Z33
4
23
59Z
31
Connections
Power is supplied via the enclosed power pack. The wires are interchangeable.
Radio connection
Make the radio connection in the vicinity of the RF module prior to mounting so that all
system components are within easy reach.
Prerequisite for the radio link is that all components receive power, which means that
the RF module must be correctly connected to the basic unit and power must be
correctly supplied to the RF repeater.
1. Press the button on the RF module for at least 8
seconds until the LED on the radio module starts
blinking at
high frequency
.
Establishment
23
59
Z
56
Button
LED
2. Press the button on the installed radio repeater
until the LED start flashing at
high frequency
.
3. The connection is established when the LED on
the RF module extinguishes.
The test is made to check the quality of the radio link.
Testing
•
The test can be aborted by pressing the ESC button.
•
While the radio link can be opened on the controller, the test should be made at the
location where the room unit will be installed
1. Press button 3 on the RF repeater for a maximum of 8 seconds until the LED
starts blinking at
low frequency
.
2. When radio communication works correctly, the LED on the RF module flashes
briefly at 10-second intervals.
3. After the test, press the button on the RF repeater again briefly until the LED
extinguishes.
Dimensions and drilling plan
90
100
32
23
59
Z
16
1
2
23
59Z
27
4,2
56
60
56
60
34/258
Siemens Switzerland Ltd
User manual RVS61.843, RVS41.813
CE1U2355en_02
HVAC Products
3 Mounting and installation
28. September 2009