Function
Description
1
Show or hide 3D heightmap.
2
User
: Apply min/max values under
Decoration Mode User
for the height range in
the captured image.
Auto Min/Max
: The system automatically determines the min/max values for the
height range in the captured image.
3
Set the height range in the captured image.
4
Display the values automatically determined by the system.
This allows the min/max values to be determined by the system and the desired
parameters based on these values to be subsequently set in
Decoration Mode
User
itself.
7.5.4.2.3
Camera Configuration
tab
Camera configuration can be used to configure specific camera settings for each
article.
NOTE
Correct configuration of the article-specific camera parameters is crucial for a success‐
ful inspection. The buttons in the following table are therefore only available to opera‐
tors with a permission level of
Authorized Client
or higher.
After the parameters have been appropriately configured for the article, the parameters
must be read from the camera and saved in the article.
During each inspection and also when the execution plan is loaded, these parameters
are read from the article configuration and loaded into the camera. This overwrites the
current parameters on the camera.
Figure 37: Camera menu page, Camera Configuration
Function
Description
1
Status indicator: Green when the article-specific parameters are loaded into the
camera at the start of the inspection.
NOTE
If the status indicator is red or the display is missing, the parameters
that are currently on the camera are used when starting the inspection. This
configuration may be unsuitable for inspecting the current article.
2
Display the parameter values
Exposure Time
,
Multi Slope Mode
,
Grab Timeout
,
Detection Threshold
and
Number Profiles per Frame
.
OPERATION
7
8027445/V1-0/2022-06-15 | SICK
O P E R A T I N G I N S T R U C T I O N S | FOS-HVS
43
Subject to change without notice
