Shinko PCA1, Инструкция по эксплуатации

Страница: 28 / 180

- 28 -
5.2 Explanation of Groups
Press the key in RUN mode. The unit moves to Pattern setting group in Group selection mode.
Select a group with the key, and press the key. Setting items in the group can be set.
If the key is pressed in the Block setting group, the unit enters setting groups such as PID block,
Alarm block.
Select a group with the
key, and press the key. Setting items in the group can be set.
If the key is pressed in the Engineering setting group, the unit enters setting groups such as Input
parameter, Output parameter.
Select a group with the
key, and press the key. Setting items in the group can be set.
Group PV Display Contents
Pattern setting group Selects the following items:
Setting pattern number, Step SV, Step time, PID block
number, Alarm block number, etc.
Block setting group
Selects the following setting groups:
PID block, Time signal block, Wait block, Alarm block,
Output block
PID block setting
group Sets the following items of blocks 0 to 9:
OUT1 proportional band, Integral time, Derivative
time, ARW, OUT2 proportional band (when DR, DS
or DA option is ordered)
Time signal block
setting group
(when the TS option is
ordered) Sets the following items of blocks 0 to 15:
Time signal output OFF time,
Time signal output ON time
Wait block setting
group Sets Wait value of blocks 0 to 9.
Alarm block setting
group Sets the following alarm values of blocks 0 to 9:
EV1 alarm value, EV2 alarm value, EV3 alarm value,
EV4 alarm value
(Appears when an Alarm type is selected in [Event
output EV
allocation].)
Output block setting
group Sets the following items of blocks 0 to 9:
OUT1 high limit, OUT1 low limit,
OUT2 high limit (when DR, DS or DA option is ordered),
OUT2 low limit (when DR, DS or DA option is ordered),
OUT1 rate-of-change
Repetitions and Pattern
link setting group
Sets the number of repetitions and pattern links.
AT Perform group
Sets the following items:
AT mode, AT Perform/Cancel, AT bias.