Shindaiwa DGK20FS, Руководство владельца и оператора

Страница: 39 / 52

36
Attach the oil filler cap.
< Note >
 Refer to section “ 8-1. Checking Engine Oil ” for engine oil
replacement amounts and types.
 After reinserting the oil drain plug and shortly after starting the
engine, be sure to always check that there is no oil leakage.
 Always be sure to wipe up any spilled engine oil.
(2) Replacing the Oil Filter
Replace Every 500 hours
Drain the engine oil. (Refer to section “ (1) Engine Oil
Replacement”.)
Remove the oil filter using a filter wrench.
Apply thin layer of oil on a new oil filter gasket.
Thread the oil filter by hand(do not use a filter wrench), and it in
until the gasket contacts the seal surface, and then tighten it with
one turn using filter wrench.
Add engine oil to the generator.
Shortly after starting the engine, always be sure to check that
there is no oil leaking from the seal surface.
< Note >
 Request the authorized distributor where the generator was purchased to
perform this procedure if you do not have a filter wrench.
 Oil filter part no.: 8944567412 (Isuzu part no.)
 Always be sure to wipe up any spilled engine oil.
(3) Air Filter Element Cleaning/Replacement
Clean Every 250 hours
Replace Every 500 hours
Remove the air cleaner clips and cleaner cap.
Remove the element.
Clean or replace the element. Attach by performing the above procedures in reverse
order.
< Note >
 Always be sure to turn the cleaner cap in the direction indicated
by the arrow.

Replace the elements earlier if using in an excessively dusty
location.

Do not add oil as this generator uses a dry element.
6
1
2
3
4
5
6
1
2
3
Gasket
Oil Drain Faucet
Open
Close
Oil Drain Plug
Oil Filter
Air Cleaner Cap
Clip
Air Cleaner