Shindaiwa DGK20FS, Руководство владельца и оператора

Страница: 30 / 52

27
(1) Manual Start
Turn off the Circuit Breaker on the operation panel of this machine.
Turn the Power Switch to ON position.
Press the Left button or Right button to select MAN mode.
Press the Start button to start the engine.
Warm up the engine for approximately 5 minutes.
< Note >
 Please keep in mind that the muffler may emit some smoke when engine is started.
Use the VOLTAGE REGULATOR dial to adjust the voltage to the specified value.
60Hz 240V
Turn the Circuite Breaker to ON to start AC power delivery.
(2) Auto Start
Turn off the Circuit Breaker on the operation panel of this machine.
Turn the Power Switch to ON position.
Press the Left button or Right button to select MAN mode.
Press the Start button to start the engine.
Use the VOLTAGE REGULATOR dial to adjust the voltage
to the specified value.
60Hz 240V
Press the Stop button to shut off the engine.
Press the Left button or Right button to select AUTO mode.
Turn the Circuit Breaker to ON position.
The engine starts when the "REMOTE START" terminal
closes.
< Note >

Please keep in mind that the muffler may emit some smoke when engine is started.

The battery is always drained while AUTO mode is selected.
Start the engine at least once 3
days to charge the battery.
9-2. Procedures during Operation
(1) Checks after Startup
 Make sure that all meters and indicators are in normal status.
(Refer to section “
5. Equipment ”.)
 Check that there is no abnormal vibration or noise.
 Check that the exhaust gas color is normal. When operation is normal, the exhaust gas
should be colorless or slightly bluish.
< Note >
 If abnormal symptoms occurs, stop using this generator and request authorized distributor
where the generator was purchased to repair the generator.
1
2
3
4
5
6
7
1
2
3
4
5
6
7
8
9
Remote Start
Terminal