Shindaiwa DGK20FS, Руководство владельца и оператора

Страница: 23 / 52

20
< Note >
 If using a single-phase 120 V (between output terminals U-N/G and W-N/G), connect an
equivalent load between U-N/G and W-N/G.
 If using a single-phase three-wire output terminal simultaneously with a receptacle output,
make sure that currents passing through each phase are less than the rated current of this
generator.
8-1. Checking Engine Oil
To check the engine oil, keep
the equipment in leveled
position, remove the oil level
gauge and wipe
so that no oil
remains, and then re-insert the
dipstick fully. Prior to starting
the engine, make sure to fill
the engine oil through the oil
filler until it reaches the MAX.
line.
< Note >
 Wait approximately five minutes or more after stopping the engine to add oil before checking
the oil level again.
 An accurate oil level reading cannot be obtained if the generator is not placed in leveled
position.
 Do not overfill with oil to avoid engine damage.
(1) Types of Engine Oil
Use only API service-type
CJ-4
class.
WARNING : INJURY
 Always turn the power switch to the OFF position and stop the engine, then close
and lock OPERATION PANEL DOOR before checking or maintaining the engine or
any equipment.
 Do not open the check door when the power switch is in the ON position. It will cause
injury by rotating parts such as cooling fans and fan belts.
CAUTION : BURNS
 Do not touch the engine and surrounding components immediately after stopping the
engine as they are still extremely hot.
CAUTION : FIRE
 Always be sure to wipe up any spilled fuel or oil.
8. Pre-Operation Inspection
OK
Not
Enough Too
Much
〇 × ×
Oil Level
Gauge
MAX
MIN
Oil Level
Gauge
Oil Filler