Shindaiwa DGK20FS, Руководство владельца и оператора

Страница: 18 / 52

15
(2) Circuit Breakaer
This switch is for transmitting electrical power to the load side. Turn to ON position to output
voltage to the output terminals. Output to the load side is cut off when there is a short circuit
or overload on the load side.
< Note >
 Do not turn ON/OFF the breaker manually to operate or stop a load.
Voltage Regulator
(3) Voltage Regulator
This dial is for regulating voltage output by the generator. Turn the dial
clockwise to increase the voltage and counterclockwise to decrease.
5-4. Fuel Piping Switch (3Way Fuel Valve)
Change the three-way fuel valve to switch to supply fuel from the external tank. In that case,
the internal fuel tank will not be used.
(1) If using the internal fuel tank
Change the lever of the three-way fuel valve turned to the “B” side to supply fuel from the
internal tank. It is turned to the “B” side when the generator is shipped from the factory.
< Note >
 When disconnecting piping from the external tank, turn the lever to the “B” side, and attach
the bundled plug (R1/2”) to the external tank fuel inlet/return.
(2) If using an external fuel tank
Connect hoses from the external fuel tank to the external fuel inlet and the external fuel
return. Change the lever of the 3way fuel valve to the “A” side to supply fuel from the external
tank.
Refer to “
9-5. Connecting with External Fuel Tank ” for corresponding procedures.
CAUTION : FIRE

Always make sure that the engine is stopped when working on piping.
 Always be sure to wipe up any spilled fuel.

After working on the piping, check that there is no fuel leakage.
External Fuel
Return Plug
External Fuel
Inlet Plug
3Way Fuel
Valve
Position B Position A