Shindaiwa DGK20FS, Руководство владельца и оператора

Страница: 14 / 52

11
⑦ UP button
Use this button to move up or increase value.
⑧
PAGE button
Use this button to switch over display pages.
⑨ DOWN button
Use this button to move down or decrease value.
⑩
ENTER button
Use this button finish editing a setpoint or moving right in the history page.
⑪ GCB button
No use.
⑫
GENERATOR status indicator
There are two states
－
Gen-set OK (indicator is green) and Gen-set failure (indicator is
red). Green LED is on if the generator voltage is present and within limits. Red LED starts
flashing when Gen-set failure occurs. After FAULT RESET button is pressed, goes to
steady light (if an alarm is still active) or is off (if no alarm is active).
⑬ GCB on
No use.
⑭
LOAD
No use.
⑮ OPERATION DISPLAY
< Note >
 The displayed information is structured into “pages” and “screen”. Use PAGE button to
switch over the pages.
(2)
Operation Display
Use Up and Down button to move between measurement pages.

Main Screen
 Operating Mode
Selecting the operating mode is done through Left and Right buttons on the front panel.
Status Screen
Contents
OFF
No start the gen-set is possible
MAN The engine can be started and stopped manually using
the Start and Stop buttons
AUTO Engine start/stop request is given by Remote start terminal
 Engine state machine
Status Screen
Contents
Init
Autotest during controller power on
Not ready Gen-set is not ready to start
Prestart Prestart sequence is in process
Cranking Engine is cranking
Pause Pause between start attempts
Running Gen set is running
Stop Stop
Shutdown Shut-down is ready to run