Shindaiwa DGK20FS, Руководство владельца и оператора

Страница: 35 / 52

32
(6) Air Filter Clogging Up
The alarm message “*Wrn Air Filter Clogging Up” will appear if the air cleaner element
becomes clogged during operation. If it illuminates, immediately stop the engine and clean or
replace the air cleaner element.
(Refer to section “10. Inspection/Maintenance (3) Air Filter Element Cleaning/Replacement”.)
(7) Fuel Level Low
The alarm message “*Wrn Fuel Level” will appear if the amount of fuel is small. Check if
there is a sufficient amount of fuel and add fuel insufficient.
(8) Overcurrent
If an overcurrent or short circuit is detected during operation, the breaker will be shut off and
automatically stopped. Use so as not to exceed the rated current.
(9) Terminal Cover Open
If the terminal cover is opened during operation, the breaker will shut off. If you use a
generatior, close it, turn off the breaker, and then turn it on again.
(10) Over Crank
If the engine fails to start, the alarm message “*Sd Start Fail” will appear, and the engine will
be automatically stopped.If that happens, set the Power Switch to Stop, and inspect the
machine. (Refer to section “12. Troubleshooting.”)
9-5. Connecting with External Fuel Tank
Turn the 3way fuel valve lever to the
“B” side.(Position for using the
internal tank.)
Remove the plugs(R1/2”) from both
the external fuel inlet and the
external fuel return.
Connect the hoses from an external
fuel tank, as shown below.
Turn the 3way fuel valve lever to the
“A” side.(Position for using the
external tank.)
Bleed air from the external tank
connecting hose. Fuel can be
supplied from the external tank after
completing the above procedures.
CAUTION : FIRE
 Always make sure that the engine is stopped when working on piping.
 Always be sure to wipe up any spilled fuel.
 After working on the piping, check that there is no fuel leakage.
1
2
3
4
5
External Fuel
Inlet Plug
External Fuel
Return Plug
3Way Fuel
Valve
Position B Position A
Return Side
Inlet Side
Return Side
Inlet Side