Shenzhen Mindray Bio-Medical Electronics Co., Ltd. DC-N2, Руководство оператора

Страница: 44 / 221

3-6 System Preparation
3.3.2 Powering OFF
You need to follow the correct procedures to power off the system. In addition, after you
upgrade the software or when the system is down, you need to power off and restart it.
If you will not use the system for a long period of time, after powering off the system, you shall
disconnect the external power supply; turn off powers of all peripherals connected to the
system.
„
To power off your system normally:
Gently press the power button once on the upper right corner of the control panel. The
[Shutdown Confirm] screen appears. See the figure below.
z
Shut down: To power off the system normally.
z
Standby: To enter the standby status.
z
Cancel: To cancel the operation.
„
To shut down the system in a direct way if you cannot do it normally:
Press and hold the power button for a long time and the system will power off without
displaying the [Shutdown Confirm] screen. Shutting down the system this way may destroy
the data.
NOTE: 1. DO NOT rush shutdown of the system in a direct way. It may destroy the
data.
2. After the software upgrade, please shut down the system in the normal way
(using “Shut down” method) so as to guarantee a fully update.
3.4 Display Adjusting
3.4.1 Position
The monitor can be rotated around its central pivot point for ±90°. Grab the bottom edge of
the display when adjusting its position.
3.4.2 Tilting Angle
When posited vertically, the monitor can be tilted for ±20° forward and backward respectively.