Shenzhen Mindray Bio-Medical Electronics Co., Ltd. DC-N2, Руководство оператора

Страница: 208 / 221

16-2 System Maintenance
b) Remained stain or dust attached to surface of transducer cable should be
washed out by cloth with clear water or soapy water, and then air-dry the
surface of transducer cable;
c) Use a soft brush to clean the transducer holder, removing dust simultaneously.
Please refer to the operator’s manual of the corresponding transducer or “12.1.5 Probes
Cleaning and Disinfection” to perform cleaning and disinfection.
NOTE: Don’t use cloth with water to clean the transducer connector.
„
Cleaning the transducer cable
a) Use soft dry cloth to wipe off stains from the transducer cable.
b) If it is difficult to clean the stains thoroughly, use soft cloth dipped with mild
detergent, and then let the cable air dry.
„
Cleaning the monitor
Using a soft cloth, apply a glass cleaner directly to the cloth and wipe down the monitor to
remove finger marks, dust and smudges. Allow the monitor to air-dry.
NOTE: 1. Do not use hydrocarbon glass cleaner or cleaner for OA (Office Automation)
equipment to clean the monitor. These substances may cause deterioration of
the monitor.
2. Keyboard on the control panel should be cleaned periodically, otherwise, keys
maybe blocked by dirt and buzzer dings, keys don’t work.
„
Cleaning Power button
z
Tool: dry soft cloth ,clear water or soapy water
z
Method:
Surface of power button should be cleaned by dry soft cloth. Remained stain should be
washed out by cloth with clear water or soapy water (NOTE: cloth should not be dipped
with too much water, which may cause electric shock), and then air-dry the surface.
„
Cleaning the control panel, covers and bracket
z
Tools: dry soft cloth, soapy water
z
Method:
Use dry soft cloth to clean the surface of the system. If the system is dirty, moisten the
soft cloth with mild soapy water and wipe off any stains. Use dry soft cloth to remove any
moisture and allow all hard surfaces to completely air-dry. If it is difficult to clean the
control panel, disassemble the keys first and then use mild soapy water to clean it.
NOTE: Keyboard on the control panel should be cleaned periodically; otherwise, keys
maybe blocked by dirt and buzzer dings, keys don’t work.
„
Cleaning Trackball
z
Tool: Soft paper or dry soft cloth, soapy water
z
Method:
a) Disassemble
Press the bulges on the clamping ring by both hands and turn the ring about
45°clockwise until it lifts. Take out the ring and the rotary ball. Be careful not to drop
the ball. Shown as follows: