Servomex SERVOTOUGH Oxy, Руководство оператора

Страница: 85 / 145

01910001B_8 © Servomex Group Limited. 2020
73
Note:
If the timer is active and you have set the repeat option, an automatic
validation/calibration will be initiated automatically at the specified times.
Note:
When an automatic validation/calibration is in progress, all new initiation requests
will be ignored (that is, initiation requests are not queued).
Close the Start Auto val switch input on the appropriate interface connec�on (see Sec�on 5.3.4)
to
ini�ate an automa�c valida�on/calibra�on. Alterna�vely, you can manually ini�ate an automa�c
valida�on/calibra�on as follows:
1. Press the
so� key on the Measurement screen (or select the "Calibrate" op�on
from the Menu screen).
2. Use the and
so� keys to select the required automa�c valida�on/calibra�on.
Figure
76 -
The Auto val/cal select screen
3. Press the
so� key.
4. Note that the date/�me of the last automa�c valida�on/calibra�on is
shown on the
screen. ("
-
" will be shown if no automa�c valida�on/ calibra�on has previously been
run).
5. Press the
so� key.
Figure
77 -
The Auto val/cal ini�ate screen
6. Press the
so� key to ini�ate the automa�c valida�on/calibra�on.
Figure
78 -
The Auto val/cal confirm screen