Servomex SERVOTOUGH Oxy, Руководство оператора

Страница: 76 / 145

64
© Servomex Group Limited. 2020 01910001B_8
Note:
If you configure one measurement alarm as ‘low’ and configure the other alarm as
‘high’, ensure that the ‘high’ alarm and hysteresis levels are higher than the ‘low’
alarm and hysteresis levels. (If you do not, the
analyser can be permanently in an
alarm condition, until you correct the levels).
1.
Select
Set up.
2.
Select the required transducer and alarm.
Figure
62 -
The Alarm set up screen
3.
Select the required mode (none, low or high), then press the so� key.
Figure
63 -
The Alarm mode screen
4. Scroll up or down to edit the appropriate se�ngs:
• Latching (Sec�on 5.20.2)
• Level
• Hysteresis (Sec�on 5.20.3)
.
’Follow’ op�on:
•
If the ‘Follow’ op�on is set to ‘No’, the alarm will be inhibited during calibra�on.
• If the ‘Follow’ op�on is set to ‘Yes’, the alarm will not be inhibited during cal.
1.
Select
Set up.
2.
Select the required alarm.