Servomex SERVOTOUGH Oxy, Руководство оператора

Страница: 59 / 145

01910001B_8 © Servomex Group Limited. 2020
47
Note:
If the switch inputs are set to ‘Remote Cal’ mode the gas control relays will not be
changed from ’sample’ during a remote low or high calibration.
See
Sec�on
6
for instruc�ons on Manual Calibra�on to ensure that your calibra�on procedure is
correctly configured.
1. In A
uto val mode, switch input pins 1
-
2 Ini�ate an Auto Valida�on/Calibra�on sequence
and switch input pins 3
-
4 stop an Auto Valida�on/Calibra�on sequence. Select
Set up
Switch Inputs.
2. Use to s
o� key to select either Auto val, Remote cal or Disabled.
5.15.4
Automatic validation/calibration target and tolerance
1.
Select: Se�ngs Auto val
2. S
elect Target, the Auto val/cal low target value screen will then be displayed.
Figure
24 -
The Auto val/cal parameters screen
3.
Edit the displayed low target value.
Figure
25 -
The Auto val/cal low target value screen
4. Edit the low tolerance value.
Figure
26 -
The Auto val/cal low tolerance screen
5.
Scroll down to the High target value then repeat steps 3 and 4 to set the High target and
High tolerance values.