22 ACU-220
SATEL
ACX-220
- hardwired zone / output expander.
Controllers
ASW-200
- wireless 230 V AC controller.
ASW-210
- flush-mounted wireless two-channel 230 V AC controller.
Other devices
APB -200
- wireless panic button.
ARF-200
- radio signal level tester.
ARU-200
- radio signal repeater.
6.2 Keypads
INT-KWRL2
– wireless keypad for operating the INTEGRA / INTEGRA Plus control panel.
VERSA-KWRL2
– wireless keypad for operating the VERSA / VERSA Plus / VERSA IP
control panel.
6.3 Keyfob
APT-200
– bidirectional keyfob.
Keyfobs are discussed in a separate section (p. 48).
7
Installation of ABAX 2 wireless devices
After the controller has been installed, you can begin installation of the ABAX 2 wireless
devices. Before installing a device, check the level of radio signal received by the device from
controller and by the controller from device at the planned installation place. The ARF-200
tester is a useful tool to check the signal level. The level of signal received by
device/controller may not be lower than 40%. You can only install the device at the planned
location after making sure that the level of the radio signal is correct. If the radio signal level
at the planned installation place is too low, select another installation location. Sometimes it
is sufficient to move the device ten or twenty centimeters to obtain a significant improvement
of signal quality.
For detailed information about installation of individual devices, please refer to the manuals of
the respective products.
7.1 Registering devices to the controller
Each wireless device, including the ARF-200 tester, must be registered to the controller.
Before adding a device that was previously registered to the ABAX / ABAX 2 system,
you must restart it (remove the battery / power the device off for 30 seconds).
When registering a device, you must enter its serial number. The serial number sticker is
affixed to the device (location of the sticker is indicated in the manual of the device). The
serial number of each ARF-200 tester is 0000500.
When registered, some devices will occupy two or more positions on the list. Therefore, the
actual number of devices that can be registered depends on how many positions will be
taken up by individual devices. For example, the expander ACX-220 can take up 4 positions.
After registering it to the controller, the pool of positions for further devices will decrease by 4
(e.g. if there were 48 positions available before registering the expander, 44 positions will
remain after registering the expander, i.e. you will still be able to register up to 44 devices).
