RST FRC-F Series, Руководство пользователя

Страница: 49 / 140

9.581.140-6
Page:
49
8.3 Adaptation of the controller parameters to the system
Press the Enter key (" E ") twice to open the General Settings menu.
In order for the motor control to work at the optimum operating point, the
system data must be entered:
Note: The data required depend on the operating mode selected.
8.3.1.1 Open Loop operating mode
See Section 9.11.
8.3.1.2 Operating Mode "Vector control with synchronous machine"
See Section 9.10.
8.3.1.3 Operating Mode "Vector control with asynchronous machine"
rated motor current
rated motor voltage
rated motor speed
rated frequency of the motor voltage
power factor of the motor. The value given on the type plate of the motor
must be multiplied by 100.
number of encoder pulses
TTL: +5V encoder (supply voltage at terminal 30)
HTL: +15V encoder (supply voltage at terminal 31)
Sine: +1Vss sine encoder (supply voltage via D-SUB socket)
Please make sure that the supply voltage connection of the encoder is connected to the
correct VVVF controller terminal (terminal 30 = +5V, terminal 31 = +15V).
FRC-F
Setting
----------------------
○
Setting
General Settings
----------------------
○
General Settings
I_MOT 32A
----------------------
General Settings
U_MOT 400V
----------------------
○
General Settings
n_MOT 1350rpm
----------------------
○
General Settings
f_MOT 50Hz
----------------------
○
General Settings
cos(phi) 80
----------------------
○
General Settings
Geber 1024
----------------------
○
General Settings
Gebertyp
----------------------
○
Encoder Type HTL(15V)
----------------------
○
Encoder Type
TTL(5V)
----------------------
○
Encoder Type
Sinus(1Vss)
----------------------
○