RLS Wacon 32-074165, Руководство по эксплуатации

Страница: 42 / 76

Safety reliably produced.
© RLS Wacon analytics GmbH ∙ +49 (0)5121 28126 0 ∙ info@rls-wacon.de
Subject to change without notice
42
Operation and handling
Analysis interval LIMESBase
The LIMESBase is supplied with a fixed analysis interval time of 10 minutes. To unlock the
analysis interval time, you need an upgrade kit, which you can purchase from us.
For more information, see page 8, 21 and 68
Input contact LIMESPlus (INPUT, start or stop analysis interval)
Different functions can be assigned to the input contact.
Programme
switch SW3 Function
OFF
• Flow monitor, switch or bridge, internal analysis
interval time
• No analysis with open input contact
For more information, see page 41
ON
•
External analysis start depending on SW1 and
SW2 switch position
• No analysis with open input contact depending on
SW1 and SW2 switch position
Flow monitor
This function is used if analyses are only to be carried out as soon as a water withdrawal takes
place. This is particularly useful for discontinuous operation, i.e., filling up a storage tank at
longer intervals or for systems that are only in operation for a few hours a day.
The function is also used when no analyses are desired, e.g., during the regeneration of a single-
filter system. For
more information, see page 41
External analysis start
The input contact is used in conjunction with a controller in the operating mode "external
analysis start". An analysis is started by pulse control on the input contact.
Note that the input contact must always be a potential-free switch. Connecting an
external voltage source can damage the unit.
Instead of a flow monitor, you can also use any other potential-free contact of a
timer or a relay (osmosis control, softening control).
In the delivery state, the programme switch SW3 = OFF and the input contact is
bridged, so that the internal analysis interval is active.
Voltage