Ricoh P7575, Руководство по эксплуатации

Страница: 91 / 451

Troubleshooting
91
Hardware Problem
HDD
The printer identified an
HDD Board error. Call your service provider.
Hardware Problem
Interposer
The interposer has a mo-
tor problem.. Turn the power switch to standby,
and then ON. If the message ap-
pears again, call your service provid-
er.
Hardware Problem
LCT
LCT has a problem with
the transfer motor. Turn the power switch standby, and
then ON. If the message is displayed
again, call your service provider.
Hardware Problem
Parallel I/F
The printer identified an
parallel interface error. Turn the power switch to Standby,
and then to ON.
Also, check the correct interface ca-
ble being used.
If the message appears again, call
your service provider.
Hardware Problem
Printer font
Problems with the font file
for the print module. It is necessary to replace the print
module.
Hardware Problem
Staple Unit
The Staple Unit is not
functioning. Call your service provider.
Hardware Problem
USB
The printer identified a
USB I/F Board error. Turn the power switch to standby,
and then ON. If the message ap-
pears again, call your service provid-
er.
Hardware Problem
Wireless Board
Access to the IEEE
802.11b board is possible,
but an error was detected. Check the board is installed correct-
ly. If the message appears again, call
your service provider.
Invalid Password
Try again
The invalid password was
entered and Locked Print
is incorrect. Enter the correct password.
Load Paper
or Form Feed
No paper remaining in the
indicated tray. Load the indicated tray with the pa-
per or select another tray using
{
Form Feed
}
, or cancel the job.
Load Paper
or Form Feed
Paper Size:
Paper Type:
The printer detected that
the actual paper type and
size in all trays are not the
same as the paper tray
size and paper type setting
when Auto Paper Select
mode is selected. Load the tray with the correct paper
or change the paper type/size using
the dial or using the Paper Input
menu on the operation panel. Alter-
natively, select another tray using
{
Form Feed
}
, or cancel the job.
Menu Protected
Cannot change
The operation panel has
been digitally locked, and
settings cannot be
changed. The printer displays this alert mes-
sage for 2 seconds before returning
to the previous panel display screen.
Messages/Second mes-
sages Causes Solutions