Ricoh P7575, Руководство по эксплуатации

Страница: 89 / 451

Troubleshooting
89
Add staples
(Booklet: Back)
The back stapler of the
Booklet Finisher is out of
staples. Add staples to the back stapler of the
Booklet Finisher.
See p.121 “Adding Staples” .
Alternatively, cancel staple mode us-
ing
{
Form Feed
}
, or cancel the job.
Add staples
(Booklet: Front)
The front stapler of the
Booklet Finisher is out of
staples. Add staples to the front stapler of the
Booklet Finisher.
See p.121 “Adding Staples” .
Alternatively, cancel staple mode us-
ing
{
Form Feed
}
, or cancel the job.
Add Toner The printer is out of toner. Replace the toner bottle.
See p.81 “Replacing Toner” .
Call Service: EC
Power Off On
Call Service if
error reoccurs
A communication error
was sent from the engine
to the controller. Turn the power switch to Standby,
and then to ON. If the message ap-
pears again, call your service provid-
er.
Cannot check
Signal in Ad hoc
An attempt to check the ra-
dio signal was made while
the communication mode
was set to
[ 802.11 Ad hoc ] in
the Maintenance menu.
To check the radio signal , select In-
frastructure in the communication
mode settings.
Cannot duplex
Tray #
The selected tray is set to
1 sided tray when duplex
mode is set. Cancel duplex mode. Alternatively,
select another tray using
{
Form
Feed
}
, or cancel the job.
Cannot select
same Tray for:
Cannot print because
main sheets and designa-
tion sheets are set to the
same tray. Press the
{
Reset
}
key.
Cancel the job and change the set-
ting for the Main sheet tray and des-
ignation sheet tray, and then try
printing the job again.
Change Setting
Tray#
The printer detected that
the user-specified paper
type is not the same as the
paper type specified in the
driver. Load the indicated tray with the cor-
rect paper, or change the paper type
using the Paper Type menu on the
operation panel. Alternatively, select
another tray using
{
Form Feed
}
, or
cancel the job.
Change Setting
Tray#
Paper Size:
Paper Type:
The printer detected that
the actual paper type and
size are not the same as
the paper tray size and pa-
per type setting. Load the indicated tray with the cor-
rect paper, or change the paper
type/size using the dial or using the
Paper Input menu on the operation
panel. Alternatively, select another
tray using
{
Form Feed
}
, or cancel the
job
Messages/Second mes-
sages Causes Solutions