Revo R4-8-16DVR2, Руководство пользователя

Страница: 13 / 109

Digital Video Recorder
5
Connector Pin Outs:
AI (1 to 16)
Alarm Inputs 1 to 16
GND
Chassis Ground
ARI
Alarm Reset In
NC
Alarm Out (Normally Closed)
C
Common
NO
Alarm Out (Normally Open)
Network Port
The DVR can be networked using the 10/100Mb Ethernet connector. Connect a Cat5 cable with an
RJ-45 jack to the DVR connector. The DVR can be networked with a computer for remote monitoring,
searching, configuration and software upgrades. See the
Network Setup
section in this chapter for
configuring the Ethernet connections.
CAUTION: The network connector is not designed to be connected directly with cable or wire
intended for outdoor use.
Factory Reset
The DVR has a
Factory Reset
switch to the left of the Alarm Output connector on the rear
panel. This switch will only be used on the rare occasions that you want to return all the
settings to the original factory settings.
CAUTION: When using the
Factory Reset
, you will lose any settings you have saved.
To reset the unit, you will need a straightened paperclip:
Turn the DVR off.  Poke the straightened paperclip in the unlabeled hole to the left of the Alarm Output connector,
and turn the DVR on.  Hold the switch until the DVR turns on and the live monitoring screen appears.  Release
the reset switch. All of the DVR’s settings are now at the original settings it had when it left the factory.
Connecting to the RS-485 Port
The RS-485 connector can be used to control PTZ (pan, tilt, zoom) cameras. Connect
TX+/RX+
or
TX-/RX-
of the control system to the
RX+/TX+
or
RX-/TX-
(respectively) of the DVR. See the
Camera
Setup
section in this chapter of this manual and the PTZ camera manufacture’s manual for configuring
the RS-485 connection.
Connector Pin Outs:
Master Unit Slave Unit
RX+/TX+ → To → TX+/RX+
RX-/TX- → To → TX-/RX-
Connecting Audio
NOTE: It is the user’s responsibility to determine if local laws and regulations permit recording audio.
Connect
Audio Out
to your amplifier using the RCA jack. Connect the audio sources to the audio
input connector of the observation cameras that are connected to the modular RJ-12 connectors of
the DVR. Refer to the observation camera manual for configuring the Audio In connection. Your
DVR can record audio from up to four sources. When installing more than four observation cameras,
only audio sources from cameras connected to the RJ-12
Video In 1
,
Video In 2
,
Video In 3
and
Video In 4
connectors will be recorded.
Connecting the Power Cord
Connect the AC power cord to the DVR and then to a wall outlet.