Revo R4-8-16DVR2, Руководство пользователя

Страница: 29 / 109

Digital Video Recorder
21
Select
/
Select All
– Activates highlighted blocks or all blocks
to detect motion.
Clear
/
Clear All
– Deactivates highlighted blocks so that they
will not detect motion.
Reverse
/
Reverse All
– Activates inactive highlighted blocks
or all inactive blocks and deactivates active highlighted blocks
or all active blocks.
Zone View
– Displays any detected motion within the zone
in red.
OK
– Accepts changes and closes Zone setup.
Cancel
– Exits Zone setup without saving changes.
NOTE: You can select the block groups to be selected or cleared by using the mouse. Place the mouse pointer
where you want to start the line. Hold down the left mouse button and drag the pointer to where you want to
end of the line. Release the mouse button and a group of blocks appears along the line you drew. You can
draw lines around shapes by repeating this process.

Min. Blocks
: Set the minimum number of detection blocks that must be activated to
trigger a motion alarm for Daytime and Nighttime independently.

Alarm-Out…
: Select the alarm-out signals (Alarm-Out and Beep) to be associated with the camera. The DVR will
alert you of the event by activating an external alarm or internal buzzer if motion is detected on the selected camera.

Notify…
: Select
Mail
if you want to send an e-mail to the address set during
NETWORK – Mail
setup when the DVR
detects motion on the selected camera.
NOTE: For the Notify action to work, the Mail should be enabled in the NETWORK – Mail setup.

Motion Ignoring Interval
: Set the motion ignoring dwell time. You can control excessive event logging and remote
notification of motion detected after the motion dwell time by adjusting the motion ignoring dwell intervals. The DVR
will not log and notify motion events occurred during the preset interval range. The recording for motion events will
not be affected by the Motion Ignoring function.

Daytime Setup…
: Select the button and set the Daytime range. The DVR will
consider the remaining time range as the nighttime.
Alarm-In Event Settings (EVENT  Alarm-In Tab)

No.
: Selecting the box toggles each alarm input On and Off.

Type
: Set each alarm input as
NO
(Normally open) or
NC
(Normally closed).

Alarm-Out…
: Select the alarm-out signals (Alarm-Out and
Beep) to be associated with the alarm input. The DVR will
alert you of the event by activating an external alarm or
internal buzzer when an input is detected on the selected
alarm input.

Notify…
: Select
Mail
if you want to send an e-mail to the
address set during
NETWORK – Mail
setup when the DVR
detects an input on the selected alarm input.
NOTE: For the Notify action to work, the Mail should
be enabled in the NETWORK – Mail setup.