REGATRON TC.ACS, Руководство по эксплуатации устройства

Страница: 53 / 66

Option: Liquid to Air Heat Exchanger TC.LAE Installation and Commissioning
REGATRON
Performance. Precision. Quality.
TC.ACS - Device Manual (V04.60) - 26.4.2022 53 / 66
11.3.2 Case Installation
The TC.LAE device is intended to be installed in horizontal position in a standard 19” case or switch cabinet with
an external air flow. It is to be placed on rails or shelves and fastened at the holes on the left and right edges of
the front panel. Usually M6 screws can be used.
11.3.3 Setting up the Cooling Circuit
To set up the cooling circuit, do the following:
 Establish the following connections via the shipped liquid hoses:
 Outlet interface for cooling circuit on the rear of the TC.ACS (see 3.2 ) to
inlet interface for cooling circuit of the TC.LAE (see 11.2 )
 Inlet interface for cooling circuit on the rear of the TC.ACS (see 3.2 ) to
outlet interface for cooling circuit of the TC.LAE (see 11.2 )
11.3.4 Connecting the TC.LAE to the Mains
To connect the TC.LAE to the mains, do the following:
 Connect the TC.LAE to the mains via the mains connection on the rear side (see 11.2 ).
CAUTION
Possible damage!
- Due to soiling and foreign bodies at the installation location
- Due to a build-up of heat
Avoidance:
- The installation location must be free of conductive and aggressive substances as well as
moisture.
- No foreign bodies such as drilling swarf or screws are to be allowed to fall into the system.
- The site conditions (see technical datasheet) must be met.
- The ventilation openings on the front panel and rear wall of the devices must not be
covered or sealed.
The following points need to be regarded:
- Rails or shelves must be robust.
- The case for a TC.LAE must be in contact over full installation depth.
- At the rear a cross-member is to be installed for additional fastening.
When the TC.LAE is placed above the TC.ACS, the Filling of Cooling Liquid is easier.