Raymarine A65, Инструкция по установке и эксплуатации

Страница: 61 / 308

ensuring that the clips along the bottom edge of the bezel latch
into position.
D 12586-1
4. Ensure the bezel is correctly aligned with the display, as shown.
5. Apply firm but even pressure to the bezel along the:
i. Outer edges - work from the sides upwards and then along
the top edge, to ensure that it clips securely into position.
ii. Inner edges - particularly along the chart card door edge, to
ensure that the bezel sits flat.
6. Check that the Power button and chart card door are free to
operate.
Removing the front bezel
Before proceeding ensure the memory card slot door is open.
D 12584-1
0
1 1
2 2 2 2
1
2
1
2
1
2
1
2
Important: Use care when removing the bezel. Do not use any
tools to lever the bezel; doing so may cause damage.
1. Place both your thumbs on the upper left edge of the display, at
the positions indicated in the diagram above.
2. Place your fingers underneath the bezel, at the positions
indicated in the diagram above.
3. In a single firm motion, apply pressure to the outer edge of the
display with your thumbs and pull the bezel towards you using
your fingers.
The bezel should now come away from the display easily.
5.3 Mounting - New c Series and New e
series
Viewing angle
000
000
000
000
000
000
000000
000000
000000
000000
D 12268-1
A B
C
D
e7 / e7D
e95 / e97 /
c95 / c97 e125 / e127 /
c125 / c127
e165
A 70º 80º 80º 80º
B 70º 80º 80º 80º
C 70º 80º 80º 70º
D
50º 60º 60º 70º
Note: The angles stated are for a contrast ratio of equal to or
greater than 10.
Product dimensions
D12269-2
A
C
E F
B
D
e7 / e7D
e95 / e97 / c95
/ c97 e125 / e127 /
c125 / c127
e165
A 233 mm
(9.17 in.) 290 mm
(11.42 in.) 354 mm
(13.94 in.) 426 mm
(16.8 in.)
B 144 mm
(5.67 in.) 173 mm
(6.81 in.) 222 mm
(8.74 in.) 281.4 mm
(11.1 in.)
C 63.5 mm
(2.5 in.) 64 mm
(2.52 in.) 69 mm
(2.72 in.) 68.4 mm
(2.7 in.)
D 180 mm
(7.09 in.) 212 mm
(8.35 in.) 256.5 mm
(10.1 in.) 295 mm
(11.6 in.)
E 160 mm
(6.29 in.) 160 mm
(6.29 in.) 160 mm
(6.29 in.) 176.6 mm
(7 in.)
F 30 mm
(1.18 in.) 31.4 mm
(1.24 in.) 32 mm
(1.26 in.) 33 mm
(1.3 in.)
Removing the rear bezel
You must remove the rear bezel before flush-mounting the display.
Note: These steps do not apply to the e165 as it does not require
a rear bezel.
Location and mounting
61