Rauch 18.1, Руководство оператора

Страница: 91 / 121

Spreading work
85
8
8.5 Spreading sand or moist salt
Observe the following when spreading sand or moist salt:

Use the RWK AX 180 agitator when spreading sand or moist salt.

Do not exceed the maximum PTO speed of 540 rpm or a spreading disc
speed of 230 rpm.

Disengage the PTO drive before transport trips.

Disengage the drive to the spreader if the metering slider is closed – also for
short periods.

Open the metering slider until the agitator can discharge the sand or moist
salt in an unhindered manner.

Engage the PTO shaft at low tractor engine speed slowly in order to prevent
damage to the agitator drive.

Always use the RWK AX 180 agitator when spreading sand or moist salt.

Always disengage the agitator when the hopper is empty.

Learn how to install and remove the RWK AX 180 agitator using the relevant
operating manual. See also Chapter
9.5.1: Removing the agitator, page 93 .

Due to the hygroscopic effect of salt, only use the spreader with a tarpaulin
over the hopper.

Avoid long-term storage of salt in the hopper.
n
WARNING
Risk of injury caused by spreading material.
Ejected spreading material can cause injury.
 Do not spread if there are persons in the danger area.
NOTICE
Depending on the quality, and under ideal conditions, rock salt can also be
spread without using the additional agitator.
NOTICE
Cleaning the machine after each use prevents deposits forming on the floor of
the hopper. This reduces the wear on the agitator mechanism and increases the
operational reliability of your spreader.