185
ESPLXD-ET Controller
Mount the Receiver/Antenna
A
Using a screwdriver or other pointed tool, punch through and
remove the antenna knock-out located on the top right of the
controller case.
b
b
NOTE:
Removing the antenna knockout with a screwdriver and
hammer is easier if the controller is NOT currently installed.
A
B
Verify the black washer (included) is in place at the base of the
antenna. Route the antenna cable through the knockout and set
the antenna into the hole.
C
Secure from the inside using the metal nut provided. Hand tighten
until snug, plus additional half turn.
b
b
NOTE:
The metal nut should be positioned with the teeth facing
upward, toward the top of the controller case.
B
C
ESPLXD-ET user-manual (670504-01) artwork_120716.indb 185
7/16/2012 3:48:59 PM
