Pulsar Zenith 140, Инструкция по эксплуатации

Страница: 75 / 161

PULSAR MEASUREMENT
75
OPTION DESCRIPTION SETPOINTS
5 = LoLo
Same as 4 = Lo, but
different identifier
6 = In bounds
Relay goes “ON” if value
is inside the zone
between the two
setpoints.
Relay Setpoints, P2 1 3, 2 2 3,
2 3 3, 2 4 3, 2 5 3, 2 6 3 and
P2 1 4, 2 2 4, 2 3 4, 2 4 4, 2 5 4,
2 6 4 can be set in any order
as the unit ‘knows’ that you
are setting an inbounds
alarm.
7 = Out of bounds
Relay goes “ON” if value
is outside the zone
between the two
setpoints.
Relay Setpoints P21 3 , 2 2 3,
2 3 3, 2 4 3, 2 5 3, 2 6 3 and
P2 1 4, 2 2 4, 2 3 4, 2 4 4, 2 5 4,
2 6 4 can be set in any order
as the unit ‘knows’ that you
are setting an out of
bounds alarm.
When P211, 221, 231, 241, 251 = 4 (L0ss of Echo) or 5 (Loss of Clock)
This parameter has no function and will not be displayed.
When P211, 221, 231, 241, 251, 261 = 6 Pump Efficiency
This parameter assigns the alarm to the appropriate pump relay a s detailed
below.
OPTION DESCRIPTION
0 = Off (Default) Relay will not operate
1 = Relay 1 Alarm is assigned to pump on Relay 1
2 = Relay 2 Alarm is assigned to pump on Relay 2
3 = Relay 3 Alarm is assigned to pump on Relay 3
4 = Relay 4 Alarm is assigned to pump on Relay 4
5 = Relay 5 Alarm is assigned to pump on Relay 5
7 = All Alarm is assigned to relays designated as pump
The
fourth parameter and the fifth parameter for each relay set the Alarm
“ ON ” and “ OFF ” points. For a high alarm, the “ ON ” is set higher than “ OFF ”.
For low alarm, then “ ON ” is set lower than “ OFF ”. See the appropriate alarm
ID, table ( P212, 222, 232, 242, 252, 262 ) for further information.