
STARTING AND STOPPING PROCEDURES
5. Connect the other end of the same black
jumper cable to the negative (-) terminal on
the booster block; If the good battery is in
another vehicle, start that vehicle's engine;
6. Let the engine run for a few minutes, then
start the motorcoach with the run-down
battery;
7. Disconnect the jumper cables in reverse
order given in steps 2 through 5;
8.
Install protective caps on the booster block
terminals.
Note :
Jumper cables must be rated at 500
cranking amperes. If jumper cable length is 20
feet (6 m) or less, use 2/0 (AWG) gauge wires.
If cable length is between 20 to 30 feet (6 to 9
m), use 3/0 (AWG) gauge wires.
MAIN POWER COMPARTMENT
5-4