OTHER FEATURES
Proceed as per instructions for setting time and
day for the first time.
If only the time is to be set, you may skip setting
the weekday by pressing (1) twice.
When the weekday has been set, press (1) to
stop the display from flashing and to store the
time and day.
Heating Without Programming (Ignition
“Off”)
Press (3). The status display (11) will show
heating symbol.
The default heating time is set to 120 minutes. It
can be changed temporarily or permanently.
Temporarily Setting Heating Time
With heater on, press (4) to decrease time
(minimum 1 minute) or (5) to increase time
(maximum 120 minutes).
Permanently Setting Heating Time
With heater “OFF” (do not press (3), press and
hold (4) (approx. 3 seconds), until display
appears and flashes.
Set heating time (from 10 to 120 minutes) using
(4) or (5).
When display disappears, the new heating time
has been stored.
Switching Off Heating
Briefly press (3).
The heating symbol will disappear from status
display (11).
System switches to automatic after-run for
cooling.
Heating Without Programming (Ignition “On’)
To switch heating “ON”, press (3). The status
display (11) will show heating symbol, as well as
time and weekday.
Heating will remain “ON” until ignition is switched
“OFF”.
If the ignition is switched “OFF”, the heating
remains switched on for 15 minutes.
This time can be increased (max. 120 minutes)
by pressing (5) or decreased (min. 1 minute) by
pressing (4).
Switching Off Heating
Briefly press (3).
The heating symbol will disappear from status
display (11).
System switches to automatic after-run for
cooling.
Programming Start Of Heating
3 switch-on times within the following 24 hours or
one switch-on time in 7 days can be
programmed. Only one switch-on time can be
activated at one time.
Selecting and activating memory:
(starting from neutral status with display visible)
First memory – press (2) once.
Memory display: 1 (default time setting 12:00)
Second memory – press (2) twice.
Memory display: 2 (default time setting 12:00)
Third memory – press (2) three times.
Memory display: 3 (default time setting 12:00)
Neutral status (no memory activated) – press (2)
repeatedly until memory display disappears.
Start of heating within 24 hours
Set the starting time:
1. Press (2) repeatedly until the desired
memory display (1, 2 or 3) flashes.
2. Briefly press and release either (4) or (5).
The program time flashes.
3. Set the heating start time using (4) or (5)
(Setting is only possible if the program time
is flashing).
To select another memory, press (2).
Start of heating after 24 hours (max. 7 days)
Set the starting time:
1. Press (2) repeatedly until the desired
memory display (1, 2 or 3) flashes.
2. Briefly press and release either (4) or (5).
The program time flashes.
3. Set the heating start time using (4) or (5)
(Setting is only possible if the program time
is flashing).
Set the program day:
4. The program day begins to flash
approximately 5 seconds after the time has
been set.
5. Set the heating day using (4) or (5).
4-14