
OTHER FEATURES
Programming Heating Start Time
Press
and the display shows the time at
which the heater will start. You can alter the
starting time by pressing either
(backwards)
or
(forwards) button. The longer you hold the
button down, the faster the display changes.
The last few minutes are set accurately by quick
pushes. The display fades after 20 seconds.
Start time 1 remains on the display, and the
yellow light stays
ON
. Starting time #1 is now
activated.
Button
allows you to program a second
starting time. Press button
which de-
activates starting time 1, then proceed as with
. The activation of the second starting time is
indicated by the symbol 2.
To Check (or activate) Start Time
Press button
or
briefly. The display
shows the programmed starting time for 20
seconds. This also programs the timer to start
the heater at the time shown.
To Cancel Heating Start Time
Press button
or
briefly. The appropriate
number in the display goes out, together with the
yellow light.
Caution :
To avoid running down the
batteries, do not turn
ON
the preheating system
for more than one hour before starting the
engine.
Warning :
The preheating system uses the
same fuel as the engine. Do not operate in a
building or while refueling. Operate only in a well
ventilated area.
110-120 VOLT CONNECTOR
(ENGINE BLOCK HEATER)
The 110-120 volt power connector is located on
the engine compartment rear door. Refer to
"Motorcoach Exterior" chapter 1. Connect the
female extension cord plug to the male
connector on the engine compartment rear door.
Connect the plug at the other end of the cord to
a 110-120 VAC outlet only.
The engine is equipped with an engine
immersion-type electric block heater to assist
cold weather starting.
The engine block heater should be used
whenever the motorcoach is parked for
extended periods in cold weather and whenever
a suitable power source is available.
Caution :
Only use a 110-120 VAC power
source. Use only a grounded type (three
pronged) extension cord with a minimum rated
current capacity of 15 amps. Disconnect the
extension cord before starting or moving the
vehicle.
4-11