OTHER FEATURES
Caution:
Only use a 110-120 VAC power
source. Use only a grounded type (three
pronged) extension cord with a minimum rated
current capacity of 15 amps. Disconnect the
extension cord before starting or moving the
vehicle.
KEYLESS ENTRY SYSTEM
By using this system, you can lock or unlock the
entrance door and the baggage and service
compartment doors. The keyboard is located
below the entrance door handle. The master
code in the microprocessor/relay module is pre-
programmed by the manufacturer and cannot be
deleted. Moreover, you can program your own
entry code (e.g. a birthday or part of a social
security number).
The master code is:
•
Printed on the owner's wallet card;
•
Printed on three decals, joined to the
owner's wallet card.
•
Printed on decal affixed to the keyless
system microprocessor/relay module in the
front console;
When you use the keyless entry system, the
keyboard and step lights illuminate.
Do not push the buttons with a key, pencil or any
other hard or sharp object as the buttons could
be damaged. Although each button is provided
with two digits separated by a vertical line, there
is only one contact per button. Press in the
center of the button (between the two digits, on
the vertical line).
You must unlock the entrance door before you
unlock any other baggage or service
compartment door. If you let more than five
seconds pass between the numbers you press,
the system shuts down, and you have to enter
your code again. If the keyless entry system
does not work properly, use the key to lock or
unlock entrance or compartment doors.
KEYLESS OPERATING INSTRUCTIONS
1. To unlock the entrance door and disarm the
anti-theft alarm, enter the permanent factory
code or the personal code. After pressing
the fifth digit, the door will unlock. During the
night, press any button to illuminate the
keyboard, then enter the code.
2. When pressing any button, the keyboard
lights up for five seconds and the step lights
illuminate for twenty-five seconds.
3. To unlock the baggage and service
compartment doors, press button 3|4 within
five seconds of entering the code.
4. To lock entrance door, compartments and
arm the anti-theft alarm system all at the
same time, press buttons 7|8 and 9|0
simultaneously.
PROGRAMMING A PERSONAL CODE
Note:
To avoid erasing the code from the
system memory, you should connect the keyless
entry system to house batteries, otherwise the
code will be erased each time battery main
disconnect switches are set to the OFF position.
You can program one personal code to unlock
the entrance door and compartments. This code
does not replace the permanent code that is
factory programmed into the system. Use your
personal code in the same manner that you
would use the original code.
Do not choose a code that presents the numbers
in sequential order, such as 1|2, 3|4, 5|6, 7|8,
9|0. Studies show that people who idly press the
buttons usually press a sequential pattern. Also,
do not select a code that uses the same button
five times. Thieves can easily figure out these
types of codes.
1. Choose and memorize your personal code.
2. Enter the original code, and within five
seconds, press button 1|2.
3. Within five seconds of pressing button 1|2,
enter your personal code, pressing each
button within five seconds of the previous
digit. The keyboard light will immediately turn
OFF
if the code is correctly entered.
The keyless entry system registers your personal
code. To unlock the entrance door, you can use
either code.
To erase your personal code, enter the original
code, press button 1|2, then wait six seconds.
REMOTE ENTRY TRANSMITTER
Up to four hand held (key fob) transmitters can
control electronic door lock system.
To unlock the entry door:
4-18