OTHER FEATURES
6. The program time and day are stored when
the time display disappears or when the
current time appears.
7. The memory display indicates the activated
memory. The flashing “heat-on” symbol (11)
also indicates that a memorized start time is
activated.
Checking activated memory
The program time of the displayed memory is
displayed for about 5 seconds. The display then
disappears or then switches to current time (if
the ignition is “ON”).
The programmed time (and day) can be
displayed by holding (2) down for five seconds.
Temperature display
If an ambient temperature sensor is connected
(Espar # 25 1482 89 41 00) and the ignition is
activated, the temperature can be permanently
displayed by pressing (1) briefly. If the ignition is
deactivated, the time temperature is displayed
for 15 seconds when (1) is pressed twice.
Timer Operating Instructions (Webasto)
WEBASTO
18046
These instructions refer to the WEBASTO timer
illustrated above
Note:
Heater timer control pad may differ from
the one described. Refer to your manufacturer's
instruction booklet for detailed operating
instructions.
To Set the Clock
If the time display e.g. 18:33 is wrong, or if it
flashes 8:88, hold
and press either
(backwards) or
(forwards). The longer you
hold the button down, the quicker the display
changes. The last few minutes are set accurately
by quick pushes. Adjust to get exact time, e.g.
23:59. The display fades after 20 seconds.
Present Time Display
Press
at any time. Present time appears on
the screen.
Manual Heating Start-Up
Press
to switch the heater on or off
immediately. The green light illuminates when
the heater is on.
Programming Heating Start Time
Press
and the display shows the time at
which the heater will start. You can alter the
starting time by pressing either
(backwards)
or
(forwards) button. The longer you hold the
button down, the faster the display changes.
The last few minutes are set accurately by quick
pushes. The display fades after 20 seconds.
Start time 1 remains on the display, and the
yellow light stays on. Starting time #1 is now
activated.
Button
allows you to program a second
starting time:
Press button
which de-activates starting time
1, then proceed as with
.
The activation of the second starting time is
indicated by the symbol 2.
To Check (or activate) Start Time
Press button
or
briefly. The display shows
the programmed starting time for 20 seconds.
This also programs the timer to start the heater
at the time shown.
To Cancel Heating Start Time
Press button or
briefly. The appropriate
number in the display goes out, together with the
yellow light.
Note:
Switch on the preheating system briefly
about once a month, even during the warm
season.
Caution:
When welding on the vehicle,
disconnect the preheater module connector in
order to protect this system from voltage surges.
4-15