OTHER FEATURES
•
Press the UNLOCK button on the
transmitter. This will unlock the door and
disarm the anti-theft system.
To unlock all compartments:
•
Press UNLOCK a second time within five
seconds of the first unlock. If more than five
seconds pass pressing UNLOCK will only
unlock the entry door.
To lock all doors and arm the anti-theft system:
•
Press LOCK on the transmitter once.
To confirm that the door and compartments have
been locked and that the anti-theft system is
armed:
•
Press LOCK again within five seconds of the
first lock. The horn will chirp once if the door
and compartments have locked. If the door
or one of the compartments are open, a door
ajar signal prevents arming of the system.
To set off the personal security alarm:
•
Press the red PANIC button on any
transmitter. The horn will sound and the
headlamps will flash for a maximum of three
minutes.
To deactivate the personal security alarm:
•
Press the red PANIC button again on any
transmitter or turn the ignition key
ON
.
Note:
the remote entry features will not function
when the ignition is in the
ON
or
ACC
. position.
Programming Transmitters
To program additional transmitters or replacing a
lost or broken transmitter, all transmitters for a
vehicle must be programmed at the same time.
The receiver assembly module erases all
previous transmitters from memory. When the
transmitters are programmed or reprogrammed,
the receiver assembly module can store up to
four transmitters in memory.
To program or reprogram transmitters into the
remote/keyless entry system, perform the
following steps:
1. Make sure that the anti-theft system is not
armed or triggered.
2. Turn the ignition key from
OFF
to
ON
five
times within ten seconds, ending in
ON
.
Refer to chapter 3, “Controls and
Instruments” for information on positions of
the ignition switch.
If the system has successfully entered program
mode, it will lock then unlock all doors.
3. Press any button on a transmitter. The
doors will lock and unlock to confirm that the
transmitter has been programmed. Repeat
for each other transmitter.
If the door locks do not respond for any
transmitter, wait a few seconds and press the
button again. If the doors still fail to respond,
call your service representative.
4. Turn ignition OFF (or wait up to five minutes
after step two). To exit program mode. If a
new set of transmitters have been
programmed or reprogrammed, the remote
control system will lock and unlock all doors
one last time to confirm.
4-19