TECHNICAL INFORMATION
or the Diagnostic Tool will display
YES
), the
Ignition Cycle Counter will be cleared and "1" will
be added to the Event Counter.
C
LEARING
T
HE
A
CTIVE
I
NDICATOR
A
ND
C
ODE
R
ECORDS
F
ROM
T
HE
C
ODE
L
IST
I
N
M
EMORY
If the conditions causing a diagnostic code to be
set are cleared, the Active Indicator can be
manually cleared by holding the
MODE
button
down continuously for 3 seconds until a tone is
heard from the shifter. To clear code records
from the list, hold the
MODE
button down
continuously for ten seconds until a second tone
sounds. All diagnostic records in the list that are
not active will then be cleared and the remaining
records will then be moved up the list.
C
ODE
R
EADING
A
ND
C
ODE
C
LEARING
P
ROCEDURES
Diagnostic codes can be read and cleared by
two methods: by using the Pro-Link 9000
Diagnostic Tool plugged into the receptacle
located in the driver's footwell or by using the
Shift Selector Display. The operation of the Pro-
Link 9000 Diagnostic Tool is described in the
user's manual provided with the Tool. This
section describes how to read and clear codes
using the Shift Selector Display.
The Diagnostic Display Mode can be entered for
viewing codes at any speed. Codes can only be
cleared when the output speed = 0 and no
output speed sensor failure is active.
Reading Codes
Read codes as follows:
1. Enter the Diagnostic Display Mode by
pressing both the "
" (up arrow) and "
"
(down arrow) push buttons at the same time,
twice on the push-button Shift Selector.
Note :
To obtain the oil level, press the "
"
(up arrow) and "
" (down arrow) push-buttons
once, at the same time. Refer to "Oil Level
Sensor (OLS) Codes" in this chapter.
2. Read the first code in the first of the five
code positions on the digital display of the
Shift Selector. For example, code "25 11" is
stored in the first position. The display will
change every two seconds as follows:
a) Code list position = "d1"
b) Main code = "25"
c) Sub code = "11"
d) Display will repeat steps a, b and c.
3. Press the MODE button momentarily to view
the second position (d2) as described in
step 2.
4. To view the third, fourth and fifth positions
(d3, d4 and d5), momentarily press the
MODE button as explained above.
5. Pressing the MODE button momentarily
after the fifth position (d5) is displayed will
return the code display to the first position
(d1).
6. Any code which is active will be indicated by
the MODE ON indicator (Active Indicator)
being illuminated while in that code position.
While in the normal operating mode, the
MODE ON indicator is illuminated to indicate
the ECONOMY mode operation. Refer to
"Controls & Instruments" chapter under
MODE.
7. Any code position in the list which does not
have a diagnostic code logged will display
"- -" for both the Main and Sub Code
displays. All positions after a code position
without any code stored will also display
"- -".
Clearing Codes
Clear codes as follows:
•
Clearing of the Active Indicator is
automatically done at ECU power-down for
all codes except code "69 34".
•
Some codes will clear the Active Indicator
automatically when the condition causing
the code is no longer detected by the ECU.
Refer to the "Diagnostic Code List and
Description" table in this chapter.
•
Manual clearing is possible while in the
Diagnostic Display Mode and after the
condition causing the code is corrected
(output speed must be zero).
1. To clear all Active Indicators, hold down the
MODE button continuously for 3 seconds
until the Shift Selector tone sounds for 0.5
second.
8-8