MOTORCOACH INTERIOR
Electric ISRI Seats
Adjust electric seats as follows:
18040
1. Tilt (rear)
Pull switch up to raise rear section of seat.
Push switch down to lower rear section of
seat.
2. Fore-and-aft/Up-Down
Push switch towards dashboard to move seat
forwards or back to move seat backwards.
Pull switch up to raise seat or push switch
down to lower seat.
3. Tilt (front)
Pull switch up to raise front section of seat.
Push switch down to lower front section of
seat.
4. Memory
•
Use switches (items 1, 2 & 3) to adjust the
seat to the position desired by driver
1
.
•
Press the
SET
button and then the number
1
button. Memory position
1
is now set.
•
To set the seat position for driver
2
, repeat
the two steps listed above except press the
number
2
button in step 2. Memory position
2
is now set.
•
To move the seat to either memory position,
press and hold the desired button (
1
or
2
) for
at least 2 seconds. If the seat does not
move, the button was not held long enough
or the seat is already in the desired position.
•
To use the easy entry/exit feature, press and
hold the number
1
and the number
2
buttons
at the same time for at least 2 seconds. The
seat will move to the full rear and full down
position.
•
To stop seat movement, push any control
button (items 1 to 4).
Note :
The seat can, at any time, be
positioned using items 1, 2 & 3 without affecting
the two memory positions.
Safety Belts
The driver’s seat is equipped with a retractable
safety belt as required by State, Provincial and
Federal regulations. To fasten, pull seat belt out
of the retractor and insert the latch plate into the
buckle until it clicks. No special adjustment is
required since the reel device is self-adjusting. If
seat belt operation becomes defective, report to
Manufacturer's Service Center.
18028
Note :
The safety belt must be pulled out
slowly and continuously, otherwise it will lock the
reel before the latch plate reaches the buckle. If
this happens, allow the belt to retract completely
and repeat the procedure correctly.
Warning :
A snug fit with the lap belt
positioned low on the hips is necessary to
ensure motorist's safety. The belt should not be
worn twisted. Avoid pinching belt and/or belt
hardware in seat mechanism. Do not wear belt
over rigid or breakable objects, such as
eyeglasses, pens or keys as these may cause
injuries.
Caution :
Never bleach or dry clean safety
belt.
2-2