MOTORCOACH EXTERIOR
18188
Keyless Entry System
By this system, you can lock or unlock the
entrance door and the baggage and service
compartment doors. The keyboard is located
below the outside entrance door handle. The
microprocessor/relay module is pre-programmed
by the manufacturer and this code can not be
deleted. Moreover, you can program your own
entry code (e.g. a birthday or part of a social
security number).
The manufacturer's code is:
•
On your owner's wallet card;
•
Taped to the microprocessor/relay module in
driver's A/C compartment;
•
Three stickers are joint to your owner's
wallet card.
When you use the keyless entry system, the
keyboard and stepwell lights illuminate. Do not
push the buttons with a key, pencil or any other
hard object as it could damage the buttons.
Although each button is provided with two digits
separated by a vertical line, there is only one
contact per button. Press in centre of button, i.e.
between the two digits where there is the vertical
line.
You must unlock the entrance door before you
unlock any other baggage or service
compartment door. If you let more than five
seconds pass between the numbers you press,
the system shuts down, and you have to enter
your code again. If the keyless entry system
does not work properly, use the key to lock or
unlock entrance or compartment doors.
Keyless Operating Instructions
1)
To unlock the entrance door, enter the five
numbers of the code. After pressing the
fifth number, the door will unlock. During
the night, press any button to illuminate the
keyboard, then enter the code.
When pressing any button, the keyboard
lights up for five seconds and the stepwell
lights for twenty-five seconds.
2)
To unlock the baggage and service
compartment doors, press button 3/4 within
five seconds after the code that unlocks the
entrance door.
3)
To lock entrance door and compartments
all at the same time, press the buttons 7/8
and 9/0 at the same time.
Programming Your Personal Code
Note :
To avoid erasing code from the
system memory, you should connect keyless
entry system to house batteries, otherwise code
will be erased each time battery main disconnect
switches are set to the OFF position.
You can program a personal code to unlock
entrance door and compartments. This code
does not replace the permanent code that is
programmed into the system. Use your personal
code in the same manner that you would use the
original code.
Do not choose a code that presents the
numbers in sequential order, such as 1/2, 3/4,
5/6, 7/8, 9/0. Studies show that people who idly
press the buttons usually press a sequential
pattern. Also, do not select a code that uses the
same button five times. Thieves can easily figure
out these types of codes.
1)
Choose and memorize your personal code.
2)
Enter the original code, and within five
seconds, press button 1/2.
3)
Within five seconds of pressing button 1/2,
enter your personal code, pressing each
button within five seconds of the previous
digit. The keyboard light will immediately
turn
OFF
if code is correctly entered.
1-5