Powis Parker Fastback 8x, Руководство по обслуживанию, Страница: 64 / 83

Page 60 FB8X Service Manual Rev. C, 9/28/10
S E R V I C E A N D C A L I B R A T I O N P R O C E D U R E S
6
6 . 1 2 G r i p T a p e
Replacing the Grip Tape on the Jaw Assembly
1. Follow the instructions to remove the Jaw Assembly
as outlined in Section 6.11.
2. Carefully peal off the existing Grip Tape.
3. After removing the Grip Tape, clean the Jaw with
Denatured Alcohol.
4. Line up the edge of the Grip Tape with the edge of
the Jaw as shown (fig 1)
5. Carefully apply the Grip Tape to the Jaw making
sure the bottom edge is flush with the bottom edge
of the Jaw.
6. Cut out the excess Grip Tape from the recess using
an Exacto Knife (fig 2 & 3).
7 Reattach the Jaw Assembly as outlined in Section
6.11.
Replacing the Grip Tape on the Carriage Assembly
1. Remove the Carriage Assembly as outlined in
Section 6.9.2.
2. Carefully peal off the existing Grip Tape.
3. Remove the Hot Symbol Label.
4. Clean the Carriage Assembly with Denatured
Alcohol.
5. Apply the Hot Symbol Label to the middle of the
Carriage Top using an exacto knife as shown (fig 4).
6. Apply the Carriage Grip Tape to the Carriage Top
making sure to line up the edge of the grip tape with
the right edge of the Carriage Top (fig 5). Slowly
separate the grip tape from the release liner as you
apply it across the Carriage Top making sure to
press out any air bubbles.
7. Verify the top edge of the Grip Tape is flush with
the edge of the Carriage Assembly (fig 6).
8. Reinstall the Carriage Assemby as outlined in
Section 6.9.2.
Fig 1
Fig 2 Fig 3
Fig 4 Fig 5
Fig 6
TOOLS REQUIRED: #1 & #2 Phillips Screwdrivers, Exacto Knife