Powis Parker Fastback 8x, Руководство по обслуживанию, Страница: 49 / 83

FB8X Service Manual Rev. C, 9/28/10 Page 45
If the same Controller Assembly is removed and then reinstalled, perform the following tasks:
TASK 1 Check the Sensors.
TASK 2 Verify heaters are plugged in by selecting the CHECK HEATER SN menu.
TASK 3 Test the heaters.
6.3.2 Installing the Controller Assembly
1. Prop the back end of the machine up
and place the Controller Assembly
underneath.
2. Connect the three Heater connections.
3. Connect the Wire Harness connections
in the front of the of the Controller
Assembly
4. Insert the Controller Assembly bracket
into the Base Plate (fig 1). Verify the
bracket is not placed outside the base
plate as shown (fig 2).
5. Lift up on the Controller Assembly and
attach to the back of the Base Plate using
the two M4x6 Screws (fig 3).
6.3.3 Changing the Fuses
1. Disconnect the Power Cord.
2. Prop the machine up and drop the
Controller Assembly down.
3. Use a fuse puller to remove the Fuses.
4. Insert the new fuse(s) by snapping them
in place by hand.
Fig 1
Fig 2
Fig 3
S E R V I C E A N D C A L I B R A T I O N P R O C E D U R E S
6
6 . 3 C o n t r o l l e r A s s e m b l y
ESD PROTECTION: Wear a Ground Strap
while working with the Controller Assembly.
If a new Controller Assembly is installed, perform the following tasks:
TASK 1 Calibrate the Book Sensor, the Strip Sensor, the Carriage, and the Heaters in CALIBRATION menu.
TASK 2 Input new A_HI/A_LO INPUT values for each of the heaters. The A HI/ A LO values are located on
each of the heater tags.
If any fuses are replaced, perform the following task:
TASK 1 Test the heaters.
Left photo: NON-RoHS / Right Photo: RoHS