Powis Parker Fastback 8x, Руководство по обслуживанию, Страница: 52 / 83

Page 48 FB8X Service Manual Rev. C, 9/28/10
S E R V I C E A N D C A L I B R A T I O N P R O C E D U R E S
6
6 . 5 B e n d e r D r i v e
Removing the Bender Drive
1. Remove the Right Cover.
2. Remove the Front Cover.
3. Remove the two M3x6 SEM PH PHIL
Screws attaching the Bender Drive to the
Right Side Plate (fig 1).
4. Disconnect the Wire Harness connector
from the Bender Drive.
Installing the Bender Drive
1. Connect the Wire Harness connector
to the Bender Drive.
2. Insert the Bender Drive through the hole
in the Right Side Plate, making sure the
sensor board is pointing towards the
inside of the machine and that the teeth
of the Bender Drive gear and the Bender
Gear engage each other (fig 2).
3. Attach the Bender Drive to the Right
Side Plate using two M3x6 SEM PH PHIL
Screws.
Fig 1
Fig 2
After replacing the Bender Motor, perform the following tasks:
TASK 1 Test the Bender Motor in the BENDER1 menu.
TOOLS REQUIRED: #1 & #2 Phillips Screwdrivers