Powis Parker Fastback 8x, Руководство по обслуживанию, Страница: 51 / 83

FB8X Service Manual Rev. C, 9/28/10 Page 47
Fig 2
Fig 3
Fig 6
After replacing the Carriage Drive, perform the following tasks:
TASK 1 Test the Carriage Motor
TASK 2 Recalibrate the Carriage Assembly in the CAL CARRIAGE menu.
S E R V I C E A N D C A L I B R A T I O N P R O C E D U R E S
6
Installing the Carriage Drive
1. Insert the half shears on the Car-
riage Drive Plate into the hole and
slot in the Right Side Plate (fig 1).
2. Attach the Carriage Drive to the
Right Side Plate using the three
M4x8 PH PHIL Screws. Ensure the
Carriage Drive Plate is flush against
the Right Side Plate (fig 2). Ensure
the Carriage Drive does not pinch
the Carriage Home Switch (fig 3).
2. Place the Carriage Back Guide
against the Right Carriage Guide in
the orientation shown (fig 4).
3. Attach the Drive Nut Bracket to
the Drive Nut as shown (fig 5).
4. Flip the Drive Nut Bracket up
and use the two M4x20 Screws
to attach the Drive Nut Bracket,
the Right Carriage Guide, and the
Carriage Guide Back together.
5. Attach the two Carriage Springs
using Needle Nosed Pliers.
6. Connect the Wire Harness connec-
tor to the Carriage Motor.
7. Cable Tie the wire to the Carriage
Motor sensor board (fig 6). The
wires must be routed to the motor
side of the circuit board.
8. Reinstall the Cooling Rack.
9. Reinstall the Right and Left Covers.
Fig 1
Fig 4
Fig 5
6 . 4 C a r r i a g e D r i v e
TOOLS REQUIRED: #2 Phillips Screwdriver, Needle Nosed Pliers, Diagonal Cutters