Powis Parker Fastback 8x, Руководство по обслуживанию, Страница: 30 / 83

Page 26 FB8X Service Manual Rev. C, 9/28/10
S E R V I C E M E N U
5
5 . 3 S e r v i c e M e n u D e s c r i p t i o n s
5.3.1 AUTOCYCLES
This option offer two choices for continuous cycling of the machine. It is recommended the while running
in either Autocycle mode, that a book or pages be inserted into the binding cavity, secured to the Book Fence with tape.
Note: Do not use a strip! If you are running continuous cycles, glue will leak out of the ends of the strip, dirtying up the
heaters.
STANDARD
Selecting this menu option causes the machine to go through full length binding cycles at normal speed.
To stop the binder, press the OPEN button when the Carriage returns to the home position and the display says
AUTOCYCLES, otherwise the binder will automatically stop the Autocycling after 500 cycles.
FAST
Selecting this menu option causes the binder to go through continuous, fast-speed cycles. To stop the cycling, press
the OPEN button when the Carriage returns to the home position and the display says AUTOCYCLES,
otherwise the binder will automatically stop the Autocycling after 500 cycles.
NOTE: To stop Autocycling at any point of the cycle, turn the machine off.
5.3.2 CALIBRATION
This option allows you to calibrate the Book Sensor, the Strip Sensor, the Carriage Assembly, and the Heaters.
CAL BOOK SENSOR
Selecting this menu option will allow you to calibrate the Book Sensor only. When calibrating the Book Sensor
make sure there is nothing in the binding recess. If the calibration is successful, a result number will appear followed
by the message “SUCCESS”. If the calibration is unsuccessful, a failure massage will appear. For more details, see
section 5.4.3, Calibrating the Book Sensor.
CAL STRIP SENSOR
Selecting this menu option will allow you to calibrate the Strip Sensor only. When calibrating the Strip Sensor make
sure there is nothing obstructing the small crescent shaped hole in the Spine Heater. If the calibration is successful,
a result number will appear followed by the message “SUCCESS”. If the calibration is unsuccessful, a failure message
will appear. For more details, see section 5.4.3, Calibrating the Strip Sensor.
CAL CARRIAGE
Selecting this menu option will allow you to calibrate the Carriage Assembly only. When calibrating the Carriage
Assembly make sure there is nothing in the binding recess. If the calibration is successful, a result number will
appear followed by the message CAL SAVED!. If the calibration is unsuccessful, a failure message will appear. For
more details, see section 5.4.3, Calibrating the Carriage Assembly.