1. Introduction and Setup
154001UA
1-5
Connect the terminal to the power source and turn on the terminal.
PRESS:
<supervisor logon character>
(default = CTRL + V)
The System Menu is Displayed
Check the following items if the System Menu does not appear.
Terminal cabling
Terminal power switch ON
Terminal speed 9600 (refer to terminal manual)
Multiplexer <supervisory logon character> is decimal 022
(default = CTRL + V) (refer to Appendix D)
Multiplexer stop bits (refer to Chapter 2)
Multiplexer parity (refer to Appendix D)
For additional information on these items refer to the indicated chap-
ters.
Table 1-1. Supervisory Port Defaults
Table 1-1. Supervisory Port Defaults
Table 1-1. Supervisory Port Defaults
Table 1-1. Supervisory Port Defaults
Table 1-1. Supervisory Port Defaults
COMMAND
PARAMETER
DEFAULT
SETTING
SUPERVISORY
PARAMETERS
SPEED
9600
DATA BITS
8
STOP BITS
1
PARITY
NONE/SPACE
RV FL CTL
NONE
(Reverse Flow Control)
MUL
MUL
MUL
MUL
MULTIPLEXER
TIPLEXER
TIPLEXER
TIPLEXER
TIPLEXER
FACTOR
FACTOR
FACTOR
FACTOR
FACTORY
YY
YY
DEF
DEF
DEF
DEF
DEFAUL
AUL
AUL
AUL
AULTS
TS
TS
TS
TS
The multiplexer is configured at the factory with a set of default parameters.
Refer to Tables 1-1 and 1-2 for the default settings.
If you want to change any of the multiplexer parameters, refer to the appropri-
ate paragraph in Chapter 2.